Case Studies
Pilot Testing Case Study
Validating performance before capital investment
Representative Project Profile
The following describes a representative application scenario for a screw press in this sector, based on typical process data and equipment configurations. It illustrates how a solution is scoped — final performance is always confirmed with your actual sludge.
The Challenge
Before committing to a permanent installation, an operator wanted documented proof of achievable cake solids and polymer demand on their specific sludge.
The Solution
A pilot screw press was run on site after jar testing. The trial produced a performance report with measured cake DS, polymer dose and capture rate, de-risking the final specification.
Typical Results
| Parameter | Value |
|---|---|
| Method | Jar test + on-site pilot |
| Deliverable | Performance report |
| Benefit | De-risked investment |
RF Series Screw Press
Compact Single-Screw Press
Entry-level unit for small treatment plants and industrial sites — inspection windows allow a view of the screw.
Explore the RF seriesEngineering Assessment
Ready to Find the Right Screw Press?
Our engineering team provides application-specific screw press sizing and selection — based on your sludge type, flow rate, and dewatering targets.