Case Studies
Brewery Case Study
Compact dewatering for brewery surplus sludge
Representative Project Profile
The following describes a representative application scenario for a screw press in this sector, based on typical process data and equipment configurations. It illustrates how a solution is scoped — final performance is always confirmed with your actual sludge.
The Challenge
A brewery with an on-site anaerobic/aerobic treatment plant needed a compact, low-noise dewatering unit for surplus biological sludge, without adding operators.
The Solution
A compact screw press was installed in the existing building. Its low noise and vibration allowed placement near production, and unattended operation matched the brewery shift pattern.
Typical Results
| Parameter | Value |
|---|---|
| Sludge type | Surplus biological |
| Cake DS | 15–20% |
| Noise | Very low |
RF Series Screw Press
Two-Screw Unit with Control Panel
Ready-to-connect dewatering unit with touch panel control, flocculation tank and cake discharge chute.
Explore the RF seriesEngineering Assessment
Ready to Find the Right Screw Press?
Our engineering team provides application-specific screw press sizing and selection — based on your sludge type, flow rate, and dewatering targets.